Standard Air-Whirlpool

STANDARD AIR-WHIRLPOOL

ELECTRONIC CONTROL
All functions of Jason's new Standard Edition Air-Whirlpool bath can be conveniently operated with Jason's electronic Air-Whirlpool touchpad, which controls the operation of the single speed whirlpool pump, the air blower, and optional LED light.

WHIRLPOOL ICON
The Whirlpool pump is activated by momentarily pressing the Whirlpool icon to start or stop the pump. This will also activate the pump timer, which will automatically stop the pump after 20 minutes of operation if not manually stopped. The low water level sensing circuit will prevent the system from operating without sufficient water.

BLOWER ICON
The Blower icon is used to activate the blower and the 20-minute timer. Pressing the icon the first time starts the blower in the constant high speed mode. Pressing the icon again begins the wave mode, indicated by a slow flashing light. Pressing the icon a third time will change the blower to pulse mode. This is indicated by a rapid light flash.

BLOWER SPEED ICON
The Blower Speed icon is used to increase or decrease the blower speed once the blower is on. Press and hold the icon to decrease the blower speed until the desired intensity is reached, then release. Press and hold the icon again to increase the blower speed until the desired intensity is reached. The blower will return to its highest speed on any mode change.

OPTION ICON
The Option icon is used to operate an optional LED light (if installed). Press the icon for less than two (2) seconds to turn the lights Off or On. Hold the icon for more than two (2) seconds to change modes. This function has a two (2) hour timer and remembers the last mode.

AUTOMATIC PURGE CYCLE
Fifteen (15) minutes after being stopped, the blower will automatically start for two (2) minutes to purge and dry the air channel.

AUTOMATIC HEATER
The air heater incorporated in the air blower will automatically operate when the blower is on to help maintain the temperature of the bath water.